Industrial Flooring Surface Preparation

Stone and laminate tiles, rubber and plastic mats, as well as steel and aluminum plate decking are a few of the popular methods for protecting garage floors.

Although, these ways give excellent results, they tend to be very costly for the common homeowner. Epoxy coating has been tested and shown to be probably the most economical and functional method of protecting garage floors for the common homeowner.

Epoxy is a resin that strongly binds to concrete thus giving a powerful and durable finish that’s usually resistant to both chemicals and stains. The nice side with epoxy is that it’s obtainable in a number of finishes that range from dull to glossy. The paint also exists within an endless variety of colors.

The most appealing part of epoxy is that you don’t require special skills to utilize it; therefore, you are able to apply it on your own; however, if you will need a professional touch, you are able to hire an expert to do it for you.

Exactly like every other do it yourself project, preparation is the main element to success. The paint doesn’t bind on a dirty surface; therefore, you should make sure that a floor where you intend to apply the paint is free of any dirt, oil, paint, and gravel. You basically have to remove all the’bad stuff’when you apply the’good stuff.’

When you have thoroughly cleaned a floor, you should allow it time to dry. If a floor have been sealed before, you should take away the old sealer. One of the finest machines that you should use to remove the sealer is a ground grinder.

Once the sealer has been removed you should then reseal the cracks and chips with the new sealer. To open concrete pores, you need to use a chemical’etcher.’

For ideal results, you should apply two coats of the paint. Once you apply the initial coat, you should leave it overnight to dry when you apply the next coat. If you’ll need a super elegant finish, you need to use a definite top-coat as the ultimate layer.

Epoxy will harden with time and you need to be in a position to walk on it within 12 hours. In order to avoid damaging the paint, it’s recommended that you give it at least four days to dry when you drive on it.

This is how you protect your garage floor using Epoxy paint. When buying the paint, you should make sure that you get it in reputable stores that won’t rip you off.

You can find different types of floor surface preparation types that concrete services contractors use to start any project. A significant point to remember is that the company hired will need to have the knowledge in carrying out the industrial flooring preparation process floor care machine. These methods have specialized equipment and contractors don’t usually provide a service not unless they are equipped to do the work. The ground surface preparation process is an essential step in industrial flooring.

You may try and sweep a floor but to learn avail, the dust keeps coming back. Now you might figure that you’ve done your best trying to completely clean the top and what the heck I’ll just paint a floor, maybe add several extra coats. This doesn’t work since garage floor epoxy paint won’t stay glued to dust for long. Needless to say it can look good when you’re done but this is the last time it can look good and goes downhill from there. You may even notice within a couple of days several small chips. From there it really gets worse.

There are always a few solutions that will assist increase the adhesion of floor paint. Start with checking your floor for signs of moisture. Put a rubber mat down on the ground or tape plastic to the top in several spots and wait several days. If you discover condensation or it gets wet underneath you will need an epoxy waterproof coating that works as a topical moisture barrier.

If a floor is free of moisture or is above a basement you should etch or have a floor mechanically prepped with a shotblaster or floor grinder. It is essential with concrete to profile the top area providing more floor for the paint to stick to. Many manufacturers suggest an acid etching solution. The issue with an acid etch with a liquid is you will be applying a really diluted ineffective solution on the floor. You could feel great that you etched the top however it probably didn’t work. Along with a diluted acid concrete is never flat. The water and acid solution will flow to the low spots having minimal impact on the high spots.

 

Other

Leave a Reply

Comment
Name*
Mail*
Website*